THE MOST COMMON BRAKE DRAG PROBLEMS

1. Residual check valve left in master cylinder.
   Solutions:  Remove residual check valve from master cylinder. If you have rear drum brakes install A10# inline residual check valve in rear hydraulic system.
   

2. No Master Cylinder Push Rod Free Play.
   solution:  Adjust push rod for adequate free play.
   

3. Air Trapped In Hydraulic System and Expands When Hot.
   Solution:  Bleed air from hydraulic system properly.  Make sure all bleed screws point up for proper bleeding.
   

4. Caliper Not Mounting Square To rotor.
   Solution:  Remount caliper properly.
   

5. After Install Test Drive (A short One) Raise Car and spin tires.  If they drag, don't drive.  re-check and if you can't locate the problem, 
   call us for consultation.